Fike DUONET - Page 20

Duonet Control Panel User Guide
20
14.
FAULT OUTPUT
Yellow Flashing A monitored output programmed to operate as a
Fault Output is in the fault state.
Continuous A monitored output programmed to operate as a
Fault Output has been disabled.
15.
DAY
Yellow Continuous The system Day / Night mode timing has been
overridden, and forced into the less sensitive day
mode.
The system has gone in the less sensitive day mode
as programmed.
16.
ROUTINE SERVICE
Yellow Continuous The pre programmed service interval has expired
and a routine maintenance check is due.
17.
TECHNICAL ALARM
Yellow Continuous A device programmed as Technical Alarm is in the
alarm state and sending a Technical Alarm signal to
the panel. No indication of a Technical Alarm is given
on the display.
18.
CONFIRMATION
Yellow Continuous A smoke detector is in the alarm confirmation state,
awaiting confirmation or reset.
19.
DELAY
Yellow Continuous An action has been started which utilises a
programmed delay.
20.
ALARMS
Yellow Flashing
Continuous
The alarm sounders have been activated from the
Sound Alarms button on the panel.
The alarm sounders have been silenced whilst
operating, and the system is awaiting a reset.
21.
BUZZER SILENCED
Yellow Continuous The control panel buzzer has been silenced whilst
operating and will stay silenced until another fault or
relevant action occurs.
The control panel buzzer has been disabled at
Access Level 3 (Engineer), and will remain silent
until it is reinstated. However, the panel buzzer will
still operate in the fire alarm state.