To Next Page
M
Mark LevySep 13, 2025
How to avoid lateral indentations with Fimer TM260?
- JJose JohnsonSep 13, 2025
Lateral indentations can be caused by excessive welding speed. Decrease the welding speed to avoid this.
How to avoid lateral indentations with Fimer TM260?
Lateral indentations can be caused by excessive welding speed. Decrease the welding speed to avoid this.
Identifies hazard symbols (danger, caution) and their meanings for safe operation.
Outlines general safety rules, user responsibility, and manual importance.
Warns about risks from electricity, fire, welding arcs, fumes, gases, and high voltage.
Covers power supply, earthing, relocation, and environmental installation requirements.
Details safe maintenance, repair, component handling, and personal protective measures.
Addresses fire prevention, work area conditions, fumes, gases, and confined spaces.
Provides guidelines for safe handling and use of gas cylinders and regulators.
Focuses on electrical safety, cable care, maintenance precautions, and electromagnetic compatibility.
Explains the MIG welding technique, components, and parameters.
Details requirements for connecting the power supply and output cables.
Identifies and explains the controls and indicators on the front panel.
Explains settings for timer, voltage/current, modes, burn back, soft start, and wire speed.
Details current range selection switches and ground connector types.
Describes cooling system interfaces and the torch quick connector.
Identifies input cable, gas pipe connector, wire spool, and feed unit components.
Guides on preparing the torch and installing a new wire spool.
Details adjusting the wire feed unit for proper wire tension and flow.
Covers wire roller selection and connecting the separate trolley to the base.
Instructions for connecting and preparing the gas cylinder and regulator.
Covers torch inspection and essential checks before starting welding.
Table and explanation for selecting welding current based on material.
Tips on torch angle, movement, environment, and wire speed adjustment.
Lists common defects and their causes and solutions.
Step-by-step guide for replacing the wire liner in the welding torch.
Instructions for accessing the rear of the unit and removing connectors.
Details positioning and connecting the cooling system control unit.
Guides on routing power cords and positioning unit components safely.
Covers replacing parts, filling liquid, and managing cables.
Steps for powering on the unit, control unit, and performing final checks.
Lists main internal components and electrical parts available as spares.
Shows the electrical schematic and component layout for TM230/TM260 models.
Shows the electrical schematic and component layout for the TM300 model.
Displays electrical schematics for TM350, TM320W, and TM360W models.
Presents electrical schematics for TM420W, TM500W, and TM650W models.
Explains compliance with WEEE directive for proper disposal of electrical equipment.
General| Brand | Fimer |
|---|---|
| Model | TM260 |
| Category | Welding System |
| Language | English |
