What to do if my Fimer Welding System suddenly stops after long use?
If your Fimer Welding System stops working after prolonged use, it likely overheated, activating thermal protection. Allow the machine to cool down until the warning message disappears.
What to do if the Fimer T252 Welding System arc keeps cutting off?
If the arc keeps cutting off while using your Fimer Welding System, it could be due to: * Poor contact between the earth clamp and the workpiece: Tighten the clamp to ensure a good connection. * A short circuit between the contact nozzle and the gas tube: Clean and replace the contact nozzle and wire-feeder tip.
Why is the welding seam porous on my Fimer T252 Welding System?
A porous welding seam on your Fimer Welding System can be caused by: * Incorrect torch angle or distance: Maintain a 5-10mm distance between the torch and the workpiece, with a tilt angle of at least 60 degrees. * Damp workpiece: Dry the workpiece using a hot air pistol or similar method.
What causes scarce fusion in Fimer Welding System?
Scarce fusion in your Fimer Welding System can result from brusque torch movements or rusty material. Cleaning the affected area is the suggested solution for both causes.
General| Brand | Fimer |
|---|---|
| Model | T252 |
| Category | Welding System |
| Language | English |
To Next Page
