FIMI X8 SE - Sticks Control; Remote Controller Pairing

In the process of auto return, toggle the auto return button to the left, the drone will hover at
place and wait for sticks instructions.
Push the five-directional button up default to access map or FPV Push the five-directional button
down default to gimbal center or down
Toggle the five-directional button left default to turn on/off battery info interface Toggle the five-
directional button right default to turn on/off self-check interface Press the five-directional button
center default to turn on/off media
Right dial to adjust EV/ISO value
Left dial to adjust pitch angle of gimbal
When auto take-off/land button turns white, it can be pressed to take off or land
When the drone meets auto take-off conditions, long press 2 seconds to take off When the drone
meets auto land conditions,long press 2 seconds to land When the drone is executing
intelligent flight, short press this button to exit
Sticks Control Remote Controller Pairing
Mode 1
Counter- clockwise
Forward
Backward
Up
Clockwise Left Right
Down
When a new remote controller or drone is replaced, please pair the remote
controller and the drone again as shown below
Turn on the drone