Note: Please turn off the power of the drone before calibrating the remote controller. RC calibration
is not available in flight
Compass Calibration
If the magnetic field changes, the compass needs to be recalibrated to ensure
flight safety. If the drone’s compass needs to be calibrated, the App will give
corresponding hints and guidance. After entering the flight control menu,
please select “compass calibration”, and then calibrate based on prompts on
the App.
Note: Please connect the drone before calibration. Compass calibration is not available in flight.
Gimbal Calibration
Click “gimbal calibration” and enter the calibration page in the gimbal settings menu.
After the drone is placed smoothly, click to start calibration. Do not move the drone during the
calibration process.
After the calibration is completed, the App interface shows “Calibration succeed”.
If the App interface shows “Calibration failed”, please recalibrate.
Note: Gimbal calibration is not available in flight.
Propellers Maintenance
Propellers are wearing parts. When they’re damaged, replace them in time to ensure flight safety
and efficiency.
Battery Maintenance
Do not throw the battery into fire; Do not batter the battery; Lithium battery’s capacity reduces
significantly in low temperature conditions. Do not use the battery when it is below 5 degrees. Do
not place the battery under the burning sun.
Gimbal Maintenance
The gimbal of X8 SE, integrated with the drone, does not need to disassemble. Please be careful
not to scratch the camera when store the drone. Please keep the camera clean for better image
quality.
Drone Self-check
To Next Page
Loading...
