Failsafe Return
Failsafe return is only supported in GPS mode. When the GPS signal is interrupted for more than 2
seconds, the flight control system built into the drone will take over the control of your drone, plan
the return path according to the original flight path, then the drone will fly back and land at the
home point. This function works precisely if there are enough GPS satellites are locked, the
compass has no interference and the home point has been recorded correctly. If the wireless
signal reconnects during the failsafe return, the pilot can turn off App return hint or toggle Auto
Return switch to the left again to cancel, and the drone will hover at the current position.
Low-power Protection
In flight, when the battery level is only enough for RTH, App advises users to return, and the drone
will return automatically after 10 seconds countdown. When the battery level is only enough for
landing, App advises users to land as soon as possible, and the drone will land automatically after
10 seconds countdown. When the battery level is at 10% usage left, the drone will be forced to
land.
100%
landing battery level
RTH battery level
current battery level
home point
home point
Hovering on the Edge of No-fly-zone
The drone will automatically hover in the restricted flight area designated by the state, such as
the edge of airports, and the App will appear corresponding hints. The user can use sticks to fly
the drone from the edge of the no-fly-zone, but the drone will not enter the no-fly-zone.
Intelligent Flight
Auto Take-off
When the conditions are right, press Auto Take-off/Landing button for 2 seconds to take off. In GPS
mode, the drone will take off to an altitude of 4 meters and hover for sticks control. In VPU mode,
To Next Page
Loading...
