25
Attendance Record Storage Option
Each time a verification is performed on the device, a transaction log will be stored inside
the terminal. These logs need to be managed to maintain the effectiveness of the devices.
However, you can only setup rules to control attendance capturing and storage.
Press Menu > System > Attendance > Select type of rules to configure
Duplicate Punch Period (m)
In the event that you want to consider all clocking activities within the predefined time
interval as a single clocking, you can use this setting. For example, if the IN time is 9:00am
and the time interval is 15 minutes, any verification done by the same ID within the 15
minutes will be considered as a same record, taking the first time he/she clocks in. The
maximum number of minutes that can be entered is 60.
Press the number button to insert the value.
Attendance Log Alert
You can set the device to prompt an alert message on screen every time it verifies an
employee when its storage is approaching the limit. The value ranges from 1 to 99 (trans-
action counts). The device will always delete earlier records to free up space to save the
latest record (FIFO, first in first out), if storage is full. By default, the value is 99. Change it
if you want to apply another value.
Cyclic Delete ATT Data
You can set the device to delete a number of records when its storage is full. The value
range is from 1 to 999 records. For example, you can set the value at 500 records and the
device will delete the first 500 records to free up the space to store new records.
Conrm Screen Delay(s)
You can set the time delay for the device to display verification results (ID, name and
photo). The time range is from 1s to 9s.
To Next Page
Loading...
