31
Punch State Required
You can set the device to only accept verification after an employee presses the status
key to validate their attendance status. The device will not respond to attempts if the
employee fails to validate their attendance status.
To enable punch state required:
Go to Menu > Personalize > Punch State Options > Press OK > Punch State Required >
Press OK to enable or disable it.
Shortcut Key Mappings
You can assign six shortcuts as attendance or functional keys. On the main interface,
when the shortcut keys are pressed, the corresponding attendance status or function
interface will display.
To shortcut key mappings setting:
Go to Menu > Personalize > Shortcut Key Mappings > Press OK to Enter > Select the
appropriate key by pressing the down arrow > Press OK to choose the corresponding
action
Note: When the Attendance Status shortcut key is selected, you can also set the
‘Auto Switch’ parameter (refer to page 30 regarding Auto Mode).
To Next Page
Loading...
