What to do if my FireAngel Smoke Alarm keeps going off?
If your FireAngel Smoke Alarm is giving frequent unwanted alarms, first check its location. Then clean the smoke alarm. If the problem persists, contact Technical Support for advice.
How to stop FireAngel Smoke Alarm going off when there's no smoke?
If your FireAngel Smoke Alarm activates when no smoke is visible, check the location of your smoke alarm. Also, clean the smoke alarm.
What to do if FireAngel Thermoptek ST-625 Smoke Alarm won't stop chirping after pressing the test button?
If the low battery warning silence chirp on your FireAngel Smoke Alarm does not silence when the test button is pressed: * You can only silence the low battery warning chirp a maximum of 10 times. Replace the batteries. If the batteries have been recently fitted and the alarm is still chirping, contact Technical Support. * If the red LED flashes at a separate time from the chirp, a fault is indicated. * If within warranty contact Technical Support. Otherwise replace immediately.
Instructions for inserting batteries correctly, noting the LED indicator and test button activation.
Procedure to test the alarm after installation by pressing the test button.
Solutions for when the smoke alarm fails to sound during the test procedure.
Advice for false alarms or activations without visible smoke presence.
Steps for when the low battery warning chirp cannot be silenced via the test button.
General| Type | Smoke Alarm |
|---|---|
| Battery Life | Up to 10 years |
| Alarm Volume | 85 dB at 3 meters |
| Test Button | Yes |
| LED Indicator | Yes |
| Operating Temperature | 0°C to +40°C |
| Warranty | 5 years |
| Sensor Type | Optical |
| Standards Compliance | EN 14604 |
| Power Source | 10-year sealed lithium battery |
To Next Page