What to do if my FireAngel Smoke Alarm activates when no smoke is visible?
If your FireAngel Smoke Alarm is activating when no smoke is visible, check its location. Also, clean the smoke alarm to ensure it is free of dust or other particles.
What to do if I experience frequent unwanted alarms from my FireAngel ST-622?
If you are experiencing frequent unwanted alarms from your FireAngel Smoke Alarm, check its location. Clean the smoke alarm. If the issue persists, contact technical support for further assistance.
What to do if the low battery warning silence chirp does not silence on my FireAngel ST-622?
If your FireAngel smoke alarm's low battery warning chirp doesn't stop when you press the test button, it might be because you've silenced it the maximum of 10 times. If this is the case, replace your smoke alarm immediately to ensure you are protected in case of a fire. Also, if the red LED flashes separately from the chirp, it indicates a fault, and you should replace the alarm immediately.
Why does my FireAngel Smoke Alarm activate when no smoke is visible?
If your FireAngel smoke alarm activates when no smoke is visible, first check its location. Also, cleaning the smoke alarm may resolve the issue.
What to do if my FireAngel ST-622 Smoke Alarm does not sound during testing?
If your FireAngel Smoke Alarm doesn't sound during testing: * Ensure the alarm is fully rotated clockwise and securely attached to the base plate to activate the power pack. If you've just activated it, wait a few seconds before testing. * Press the center of the test button firmly. * If the unit was silenced and is in low sensitivity mode, wait 15 minutes and try again. * If the alarm was recently fitted and still fails the self-test, contact technical support.
What to do if the low battery warning silence chirp does not silence when the test button is pressed on my FireAngel ST-622?
If the low battery warning silence chirp on your FireAngel Smoke Alarm doesn't stop when you press the test button: * Note that you can only silence the low battery warning chirp a maximum of 10 times. Replace the smoke alarm immediately. * If the red LED flashes at a different time than the chirp, this indicates a fault. * If the alarm is within its warranty period, contact Technical Support. Otherwise, replace it immediately.
Why do I experience frequent unwanted alarms from my FireAngel ST-622?
If you are experiencing frequent unwanted alarms from your FireAngel smoke alarm, first check its location. Also, cleaning the smoke alarm may resolve the issue.
How to troubleshoot a FireAngel ST-622 that does not sound during testing?
If your FireAngel smoke alarm doesn't sound during testing, make sure it has been rotated clockwise as far as it can go and is securely located on the mounting plate. This ensures the power pack is activated. If you've just activated the alarm, allow a few seconds before testing. Also, make sure you firmly push the center of the test button. If the unit has been silenced and is in low sensitivity mode, wait 15 minutes before trying again.
Explains how the alarm's power pack is automatically enabled when fitted.
Details the combined optical and thermal sensing technology for improved fire detection.
Explains the unit's behavior and replacement advice during low power.
General| Model | ST-622 |
|---|---|
| Category | Smoke Alarm |
| Alarm Sound Level | 85 dB at 3 meters |
| Standards Compliance | EN 14604:2005 |
| Warranty | 5 years |
| Operating Temperature | 0°C to 40°C |
| Operating Humidity | Up to 90% RH non-condensing |
| Dimensions | 132mm x 132mm x 50mm |
| Sensor Type | Thermoptek |
To Next Page
