What to do if I experience frequent unwanted alarms from my FireAngel Smoke Alarm?
If you are experiencing frequent unwanted alarms, check the location of your smoke alarm to ensure it is appropriately positioned. Cleaning the smoke alarm may also resolve the issue.
What to do if my FireAngel Thermoptek ST-632 emits a brief beep intermittently?
First, verify that the beeping is indeed coming from your smoke alarm and not another device such as a carbon monoxide, gas, or burglar alarm. If the brief beep occurs every 45 seconds, accompanied by a flashing yellow LED, it indicates a low battery. In this case, replace the unit within 30 days. Also, check the location of your smoke alarm.
What does it mean when the yellow LED is flashing and the FireAngel Thermoptek ST-632 Smoke Alarm is emitting a short ‘chirp’?
If the yellow LED flashes around the same time as the chirp, this indicates low power status, and the alarm should be replaced as soon as possible, within a maximum of 30 days. If the yellow LED flashes at a different time to the chirp, this indicates a fault, and the alarm should be replaced as soon as possible.
Why does my FireAngel Thermoptek ST-632 Smoke Alarm activate when no smoke is visible?
If your FireAngel smoke alarm is activating when no smoke is visible, check its location to ensure it is appropriately positioned. Also, cleaning the smoke alarm may resolve the issue.
How to troubleshoot a FireAngel Thermoptek ST-632 Smoke Alarm that does not sound during testing?
First, ensure the alarm has been rotated clockwise as far as it can go and is securely located on the base plate, activating the battery. If testing immediately after activation, allow a few seconds for the alarm to settle. Make sure you firmly push the center of the test button. Check the LED flashing pattern. If the unit has been silenced and is in low sensitivity mode, it may not test; wait 15 minutes and try again. If the alarm has been recently fitted and still fails to self-test, contact technical support.
Explains what happens when the alarm detects smoke and the LED indication.
Details how to identify and respond to a fault condition in the alarm.
Explains the audible and visual indicators of a low battery and recommended actions.
Step-by-step guide on how to perform a monthly test of the smoke alarm.
Recommends monthly testing, refer to 'Alarm Test' section.
Solutions for when the smoke alarm fails to sound during a test.
General| Brand | FireAngel |
|---|---|
| Model | Thermoptek ST-632 |
| Category | Smoke Alarm |
| Language | English |
To Next Page