Firman P08004 - Page 12

English Customer Service: 1-844-FIRMAN1
1. Axle pin . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Improper treatment of generator could damage
2. 10.0" in. Wheel . . . . . . . . . . . . . . . . . . . . . . . . . 2
it and shorten its life.
3. Flat Washer. . . . . . . . . . . . . . . .. . . . . . . . . . . . . .2
•
•Use generator only for intended uses.
4. Cotter pin. . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . .2
If you have questions about intended use,
5. Engine Oil(Bottle) . . . .. . . . . . . . . . . . . . . . . . . .1
ask dealer or contact local service center.
6. Oil Funnel . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . 1
•
•Operate generator only on level surfaces.
7. Wrench for Spark plug . . . . . . . . . . . . . . . . . . . .1
DO NOT expose generator to excessive
8. Double Open wrench (10mm & 12mm). . . . 2
moisture, dust, dirt, or corrosive vapors.
9. Support Leg with Vibration Mounts . . . . . . 1
•DO NOT insert any objects through cooling
10. Flange Bolt (M8x16 for Support Leg) . . . . . 2
slots.
11. Flange Lock Nut (M8) . . . . . . . . . . . . . . . . . . . 4
•If connected devices overheat, turn them off
12. Handle . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . 1
and disconnect them from generator.
13. Flange Bolt (M8x50 for Handle) . . . . . . . . . 2