Firman P08004 - Maintenance Schedule and Engine Care

English Customer Service: 1-844-FIRMAN1Page
16
2.Restart engine and if the engine stops again a
low oil condition may still exist. DO NOT try to
restart the engine.
3.Contact an Authorized FIRMAN Service Dealer.
4.DO NOT operate engine until oil level is
corrected.
Do Not Overload Generator
Overloading a generator in excess of its rated
wattage capacity can result in damage to the
generator and to connected electrical devices.
To prolong the life of your generator and attached
devices, follow these steps to add electrical load:
1. Start the generator with no electrical load
attached.
2. Allow the engine to run for several
minutes to stabilize.
3. Plug in and turn on the first item. It is best
to attach the item with the largest load first.
4. Allow the engine to stabilize.
5. Plug in and turn on the next item.
6. Allow the engine to stabilize.
7. Repeat steps 5-6 for each additional item.
MAINTENANCE AND STORAGE
MAINTENANCE SCHEDULE
ITEM
NOTES
Daily(Before
operation)
Initial
25 hours
Every
50 hours
Every 100
hours
(or annual)
Spark Plug
Check condition. Adjust gap and
clean. Replace if necessary.
√
Engine Oil
Check oil level.
√
Replace.
√
√
Air Filter
Clean, replace if necessary.
√
Fuel Filter
Clean fuel filter and fuel tank
strainer. Replace if necessary.
√
Fuel Line
Check fuel hose for cracks or other
damage. Replace if necessary.
√
Exhaust
System
Check for leakage. Retighten or
replace gasket if necessary.
√
Check spark arrester screen.
Clean/Replace if necessary.
√