English Customer Service: 1-844-FIRMAN1Page 11
9. Do not over-choke. As soon as engine starts and warms up,
move the choke lever to the “RUN” position.
fuel valve to the “ON” (l)position.
4. Turn the
10. Allow generator to run at no load for few minutes upon each
initial start-up to permit engine and generator to stablize.
5. Flip the engine switch to the “RUN(l)” position.
When starting engine, pull cord slowly until resistance is felt and
then pull rapidly to avoid kickback.
battery switch to the "ON"(l) position. 6. Flip the
Keep choke lever in “START” position for only 1 pull of the recoil
starter. After first pull, move choke lever to the “RUN” position for
up to the next 3 pulls of the recoil starter. Too much choke leads to
sparkplug fouling/engine flooding due to the lack of incoming air.
This will cause the engine not to start.
Starting the Generator (Electric Start)
Electric Start and Remote Start Operations
To Next Page
Loading...
