– 38 –
Arming Perimeter Only
(With Entry Delay OFF)
Using the 7 INSTANT Key
Use this key when you are staying home and do not expect anyone to use the
entrance door.
When armed in INSTANT mode, the system will sound an alarm if a
protected door or window is opened, but you may otherwise move freely
throughout the premises. The alarm will also sound immediately if anyone
opens the entrance door.
The system provides three INSTANT modes; INSTANT mode 1, 2 and 3.
INSTANT modes 1 and 2, when activated automatically bypass specific zones
assigned by your installer to each of the INSTANT modes. INSTANT mode 3,
when activated automatically bypasses all zones assigned to INSTANT
modes 1 AND 2. Check with your installer for a list of the zones that are
bypassed during each INSTANT mode.
Close all perimeter windows and doors before arming (see
CHECKING FOR OPEN ZONES section)
INSTANT
1. Enter your security code and press 7 + 1 for INSTANT Mode 1.
Enter your security code and press 7
+ 2 for INSTANT Mode 2.
Enter your security code and press 7
+ 3 for INSTANT Mode 3.
NOTE: If none of the zones in a partition are assigned to INSTANT mode 2,
then when the user enters [User Code] + [7] (INSTANT), all zones assigned
to INSTANT mode 1 are automatically bypassed.
2.
ARMED *INSTANT1
ZONE BYPASSED
The keypad beeps three times, displays the
armed message and indicates which INSTANT
mode (1, 2, or 3).
Note: "ZONE BYPASSED" in this display
simply indicates that some zones of protection
are not armed when using INSTANT mode.
To Next Page
Loading...
Need help?
General
