The CM-900 will also provide a door unlock output as soon as the key is turned off or 12v ignition
is removed from the CM-900.
FO3 - RPM locking: (Tach input is required for this option to operate properly.) This option
will provide a door lock output at approximately 20% RPM over the programmed idle tach output.
(i.e. program tach at 1000 rpm and doors will lock at a sustained 1200 rpm when moving.) The
CM-900 will also provide a door unlock output as soon as the key is turned off or 12v ignition is
removed from the CM-900.
1-11
Ignition + Accessory Pulse with Disarm
:
FO1 - Off:
(default)
FO2 - Ignition (+) and (-) pulse output with disarm:
This option will pulse both (+) and (-) ignition
wires upon unlock/disarm.
Most new Ford vehicles require ignition pulsed + immobilizer with
unlock to disarm the factory alarm.
FO3 - Accessory (+) and (-) pulse output with disarm:
This option will pulse both (+) and (-)
accessory wires upon unlock/disarm.
FO4 - Ignition (+) and (-) pulse and Accessory (+) and (-) pulse output with disarm: This
option will pulse both (+) and (-) ignition and accessory wires upon unlock/disarm. Some new Ford
vehicles require ignition and accessory pulsed + immobilizer with unlock to disarm the
factory alarm. Important: Also used in cases where the vehicle’s radio may turn on and stay on
until the door is opened when accessory is pulsed.
1-12 Arm and Disarm Remote Paging by Datalink Module
: This feature disables the arming,
disarming, and remote start confirmation updates to any Firstech 2 Way LCD when using an OEM
remote.
FO1 - On:
(default)
FO2 - Off: This feature disables the page back update to the 2 Way Firstech remote when your
interface module provides OEM remote status updates to the CM-900.
1-13 Double Pulse Disarm
: This feature enables the FAD output. It will pulse 2 times with a single
disarm command.
FO1 - Off (default):
Standard single pulse output on the FAD wire.
(orange/white by default)
FO2 - On: This feature will generate a double pulse output on the FAD wire. (orange/white by
default)
1-15 Trunk Output Timing
: This feature determines the length of output time for the (+) or (-) analog
trunk release wire.
FO1 - 1 Second:
(default) Will provide a 250mA (-) negative output for 1 second on any POC that
is programmed for trunk release or setting 28.
FO2 - 2 Seconds:
FO1- 1 Second: (default) will provide a 250mA (-) negative output for 2 seconds
on any POC that is programmed for trunk release or setting 28.
FO3 - 3 Seconds:
FO1- 1 Second: (default) will provide a 250mA (-) negative output for 3 seconds
on any POC that is programmed for trunk release or setting 28.
FO4 - 4 Seconds: FO1- 1 Second: (default) will provide a 250mA (-) negative output for 4 seconds
on any POC that is programmed for trunk release or setting 28.
1-16 Siren/Horn mute control
: this feature allows the installer to enable or disable the siren/horn mute
control. The mute feature will silence the siren or horn during arm, disarm, and start from the
Firstech remote.
FO1 - Disabled:
(default) will not allow for the Firstech remote to mute the siren or horn output.
To Next Page
Loading...
