4-03
Aux 1 Output Control:
This feature allows the user to configure the method of which Auxiliary 1
can be activated.
FO1 - Remote:
(default) This option allows AUX 1 (output time based on feature 4-01) to be
triggered by any 4 button Firstech remote or drone.
FO2 - With Arm:
This option will trigger AUX 1 (output time based on feature 4-01) any time the
CM-900 is locked/armed the first time (i.e. if you send a second lock/arm command it will not
trigger again)
FO3 - With Disarm:
This option will trigger AUX 1 (output time based on feature 4-01) any time the
CM-900 is unlocked/disarmed.
Note: the system has to be in the armed state when disarming
in order to trigger AUX 1. (I.e. if the vehicle is already in the unlocked/disarmed state and
you send a second unlock/disarm command it will not trigger the output)
FO4 - With ignition removed:
This option will trigger AUX 1 (output time based on feature 4-01)
as soon as Ignition input is removed from the CM-900. (I.e. this feature can be used with a manual
transmission vehicle to open the door input circuit on the CM-900 for a set period of time when
reservation mode is complete in order to prevent the dome light from cancelling reservation mode.)
4-04 Aux 2 Output Control:
This feature allows the user to configure the method of which Auxiliary 2
can be activated.
FO1 - Remote:
(default) This option allows AUX 2 (output time based on feature 4-02) to be
triggered by any 4 button Firstech remote or drone.
FO2 - With Arm:
this option will trigger AUX 2 (output time based on feature 4-02) any time the
CM-900 is locked/armed the first time (I.e. if you send a second lock/arm command it will not
trigger again)
FO3 - With Disarm:
This option will trigger AUX 2 (output time based on feature 4-02) any time the
CM-900 is unlocked/disarmed. Note: the system has to be in the armed state when disarming in
order to trigger AUX 1. (I.e. if the vehicle is already in the unlocked/disarmed state and you send a
second unlock/disarm command it will not trigger the output)
FO4 - With Start:
This option will trigger the AUX 2 (output time based on feature 4-02) when the
remote start sequence is initiated. It will trigger at the same time as GWR (ground when running)
4-05 Secure Aux Output:
This feature is designed to prevent accidental activation of the AUX outputs
by requiring an additional step when using any 4 button or 2 way LCD Firstech remote.
FO1- On:
(default) this option will require the user to perform an additional step before activating
AUX output using any Firstech 4 button or 2 way LCD remote (2way remotes with Roman numeral
buttons will require a 0.5 second tap of button IV before activating any of the AUX outputs.2Way
LCD remotes with lock/unlock/trunk/start icons on the buttons use the start button for the same.
1way remotes require the user to hold trunk + start buttons for 3 seconds before activating AUX
outputs.)
FO2- Off:
This option will disable the additional step required by the user to activate the AUX
outputs.
*NEW* FO3- On while armed:
This feature will only require the user to perform the additional
override step to activate Aux outputs
ONLY WHEN
the CM-900 is
ARMED
. While the system is
disarmed or unlocked this step is not required.
To Next Page
Loading...
