www.firstechonline.com
|
www
.compustar.com
Copyright 2022 Fi rstech , LLC. “Are you not entertained…?” Page
25
Universal Security Control Module
Install.myfirstech.com
CM2500
Master
Guide
1-07 Auto Relock:
FO1 - Off: (default)
FO2 - 30 seconds: This option allows the CM2500 to automatically relock/rearm 30 seconds
after
CM2500 has been disarmed/unlocked and ONLY IF no zones have not been opened.
FO3 - 60 seconds: This option allows the CM2500 to automatically relock/rearm 60 seconds
after
CM7 has been disarmed/unlocked and ONLY IF no zones have not been opened.
FO4 - 5 minutes: This option allows the CM2500 to automatically relock/rearm 5 minutes after
it has been disarmed/unlocked and ONLY IF no zones have not been opened.
1-08 Passive Arming: When options 2 or 3 are selected the user has the choice to activate “Passive”
feature using a Firstech remote or Drone (please check specific remote user ’s manual for steps
to activate passive)
FO1 - Off: (default)
FO2 - Passive locking with passive arming: This option when passive is activated, will send
lock/arm outputs to lock/arm the CM2500 30 seconds after the last zone is closed. The CM2500
will flash the parking lights and chirp the siren 1 time every 10 seconds 3 times total as a
warning that it is going to Arm/lock itself.
FO3 - No lock output with Passive arm: This option, when passive arm feature is activated, will
NOT send the lock command one the CM2500 has passively armed itself. The CM2500 will flash the
parking lights and chirp the siren 1 time every 10 seconds 3 times total as a warning that it is going to
arm itself.
FO4 - “Passive Locking/Arming with RFID”: This option will allow the Passive locking with
Passive arming to LOCK/ARM the system 15 seconds after an RFID capable remote has left
proximity of the antenna. IF THE REMOTE IS WITHIN RANGE OF THE ANTENNA FOR 5
MINUTES OR MORE, CM WILL STOP THE PASSIVE ARMING SEQUENCE.
ANY ACTION FROM A FIRSTECH REMOTE, DRONE, KP SENSOR, IGNITION ON, OR
ZONE OPEN WILL AUTOMATICALLY RE-START THE PASSIVE ARMING SEQUENCE.
1-09 Dome Light Delay: This option is used when connecting the door trigger input to the vehicles
dome light circuit. It delays the door trigger input to prevent the door open icon displaying on 2
Way remotes upon lock/arm.
FO1 - Off: (default)
FO2 - 5 seconds: This option will delay the door trigger input for 5 seconds when arming the
system to account for any vehicle dome light output delay.
FO3 - 45 seconds: This option will delay the door trigger input for 45 seconds when arming the
system to account for any vehicle dome light output delay.
FO4 - Auto: This option will allow the CM2500 to wait for a change in polarity on the door
input circuit, after the system has been armed, to monitor for security.
To Next Page
Loading...