www.firstechonline.com
|
www
.compustar.com
Copyright 2022 Fi rstech , LLC. “Are you not entertained…?” Page
26
Universal Security Control Module
Install.myfirstech.com
CM2500
Master
Guide
1-10 Valet Mode: This feature will change the enter/exit valet mode procedure based on the option
selected.
FO1 - Key cycle 5 times or Remote (Lock + Trunk) while Ignition is on: This option allows
the user to enter valet mode using either method described. Note: the user may exit valet mode
with their Firstech remote (please check users guide for each remote for valet mode exit
procedure), or with the key to ignition or “on” position and press the foot brake 10 times within
10 seconds (MUST HAVE CN4 PIN 6 connected to foot brake with feature 1-14 set to
option 2).
FO2 - Key cycle 5 times or Remote (Lock + Trunk): This option allows the user to enter valet
mode using either method described. Note: the user may exit valet mode with their Firstech
remote (please check users guide for each remote for valet mode exit procedure), or with the key
to ignition or “on” position and press the foot brake 10 times within 10 seconds (MUST HAVE
CN4 PIN 6 connected to foot brake with feature 1-14 set to option 2).
FO3 – (-)NEG Valet Input: This option will allow a (-)PIC set to 22 “Valet Input” to be used as a
wired Valet mode enter/exit option. When this option is selected the previous Valet enter/exit options
will no longer work, except when using Drone Mobile.
This input will require (-)NEG input for 5 seconds minimum, followed by 5 (-)NEG input pulses to
enter/exit Valet mode.
Any PIC set to Valet Input can be connected to a momentary or latching toggle switch mounted
somewhere in the vehicle. NOTE: When using this option for security purposes, make sure the
switch is mounted in a discreet location, but it also must be accessible to the user.
1-11 Open door warning: With this feature enabled the system will notify the user if a zone is opened
when arming. The system will provide 3-4 chirps and parking light flashes when attempting to
arm the system with a zone open
FO1 - On: This option enables the door/zone open warning action
FO2 - OFF: This option disables the door/zone open warning action
1-12 Security features:
This
feature
will
enable or disable the security features of the
CM2500
.
Security
features include sensor inputs, zone inputs (unless using
with
manual transmission), horn, and
siren output. Basic features
will
function normally (lock, unlock, trunk release, remote
.,
parking
lights.)
FO1
-
On: This option his option
will
enable
security f
eatures
FO2
-
Off: This option
will
disable security
features, leaving only keyless entry and trunk
release functions operational.
1-13 Siren/Horn mute control: this feature allows the installer to enable or disable the siren/horn
mute
control. The mute feature
will
silence the siren or horn during arm, disarm, from the
Firstech
remote.
FO1
- Disabled:
(default)
will
not allow for the Firstech remote to mute the siren or horn
output.
To Next Page
Loading...