www.firstechonline.com
|
www
.compustar.com
Copyright 2022 Fi rstech , LLC. “Are you not entertained…?” Page
27
Universal Security Control Module
Install.myfirstech.com
CM2500
Master
Guide
FO2 - Enabled: this option will allow the end user to activate or deactivate the arm/disarm
chirps using a Firstech 4/5 button remote or DroneMobile.
1-14 (+) INPUT CN4 PIN 6: This feature will change the behavior of PIN 6 RED/BLACK (+) INPUT.
FO1 - (+) Door zone input: this option will identify PIN 6 RED/BLACK wire as a (+) door
zone input for security purposes.
FO2 - (+) Foot Brake input: This option will identify PIN 6 RED/BLACK wire as a (+) Foot
brake input for drive lock and valet mode purposes
1-15 FT- RFID Function: This feature covers the RFID unlock options. (Please refer to the FT-RFID
section of this manual for specific operation instructions and antenna mounting locations)
FO1 - Unlock “unlock once armed” (default): (The CM must be in an armed state for this
option to function) This option will enable the FT-RFID proximity unlock/disarm feature after
activating with a Firstech RFID enhanced remote. (Refer to the FT-RFID section of this manual
for specific operating instructions). Approximately 12 seconds after armed, the ANT-2WSF will
activate the proximity field and once the RFID enhanced remote enters the field the system will
disarm/unlock automatically
FO2 - FTX Unlock “always unlock”: This option will enable the FT-RFID proximity unlock
feature once activated with a Firstech RFID enhanced remote. The CM will always send the
unlock/disarm output when the remote enters/re-enters the proximity field regardless of the
current state of the CM. (i.e., armed/locked-disarmed/unlocked). Once the remote leaves the
proximity field, it will be set to send the unlock/disarm output as soon as it enters/re-enters.
Note: because the ANT-2WSF antenna is always searching for the remote, it will produce
more current draw than the standard RFID unlock option 3.
FO3 - Off: Disables the RFID function.
2-01 Horn output: This feature controls the horn output behavior during Arm, Disarm, and Alarm
trigger
FO1 - On double lock only: (default) this option is designed to simulate a factory keyless entry
system by providing a horn output pulse (based on the option selection of feature 1-06) each
time the lock command is sent a second time within 8 seconds of the first lock command.
FO2 - On lock and Unlock only: this option will provide a horn output pulse (based on the
option selection of feature 1-06) with each lock or unlock confirmation.
FO3 - With Alarm trigger only: this option will provide a horn output pulse (based on the
option selection of feature 1-06) with a full alarm trigger only.
2-02 Horn Honk: This feature controls the output behavior when activating the Horn
FO1 - Pulsed: this option provides a pulsed output pulse (based on the option selection of
feature 1-06)
FO2 - Latched: this option will provide a latched output when an alarm event is triggered. This
option can be used to activate accessories that may be installed for security purposed such and
strobe lights or air horn kits.
To Next Page
Loading...