Firstech CM2500 - Page 29

Alarm
System
www.firstechonline.com | www .compustar.com
CM2500
Install
Guide
Copyright 2022 Fi rstech , LLC. “Are you not entertained…?” Page
29
Universal Security Control Module
Install.myfirstech.com
CM2500
Master
Guide
FO2 - 2 Seconds: Will provide a 250mA (-) negative output for 2 seconds
FO3 - 3 Seconds: Will provide a 250mA (-) negative output for 3 seconds
FO4 - AUX 3 programmable: Will provide a 250mA (-) negative output for a programmable
timed output based on special options group AUX 3 settings 1-100 seconds. SEE feature 2-05
for trunk release output wire options
2-07 Secure Aux Output: this feature is designed to prevent accidental activation of the AUX outputs
by requiring an additional step when using any 4 buttons or 2-way LCD Firstech remote.
FO1 - On while armed: this feature will only require the user to perform the additional override
step to activate Aux outputs ONLY WHEN the CM2500 is ARMED. While the system is
disarmed or unlocked this step is not required.
FO2 - On: (default) this option will require the user to perform an additional step before
activating AUX output using any Firstech 4 button or 2-way LCD remote. 2Way LCD remotes
with lock/unlock/trunk/. icons on the buttons use the . button for the same. 1way remotes require
the user to hold trunk + . buttons for 2.5 seconds before activating AUX outputs.)
FO3 - Off: this option will disable the additional step required by the user to activate the AUX
outputs.
2-08 Aux 1 Output: This feature determines the duration of the auxiliary 1 output. (Option 4 allows
the output duration to be set for a specific length of time 1-99 sec. (Specific time setting only
available when using the OP500)
FO1 - 500mS: This option will provide a (-) negative output for 500 milliseconds (Half second)
output using Yellow AUX 1 output PIN 13 CN4
FO2 - Latched: This option will provide a latched (-) negative output using Yellow AUX 1
output PIN 13 CN4. Note: This will stay latched until AUX 1 command is sent again to shut it
off.
FO3 - 20 second pulsed output: this option will provide a (-) negative output for 20 seconds
using Yellow AUX 1 output PIN 13 CN4
FO4 - Program: This option allows the AUX 1 output time to be programmed for a duration
between
1-99 seconds.
2-09 Aux 2 Output: This feature determines the duration of the auxiliary 2 output. (Option 4 allows
the output duration to be set for a specific length of time 1-99 sec. (Specific time setting only
available when using the OP500)
FO1 - 500mS: This option will provide a (-) negative output for 500 milliseconds (Half second)
output using Yellow/White AUX 2 output PIN 15 CN4
FO2 - Latched: This option will provide a latched (-) negative output using Yellow/White AUX
2 output PIN 15 CN4. Note: This will stay latched until AUX 1 command is sent again to shut
it off.