www.firstechonline.com
|
www
.compustar.com
Copyright 2022 Fi rstech , LLC. “Are you not entertained…?” Page
30
Universal Security Control Module
Install.myfirstech.com
CM2500
Master
Guide
FO3 - 20 second pulsed output: this option will provide a (-) negative output for 20 seconds
using Yellow/White AUX 2 output PIN 15 CN4
FO4 - Program: This option allows the AUX 2 output time to be programmed for a duration
between
1-99 seconds.
2-10 Aux 1 Output Control: This feature allows the user to configure the method of which Auxiliary
1 can be activated.
FO1 - Remote: (default) This option allows AUX 1 (output time based on feature 2-08) to be
triggered by any 4 button Firstech remote or drone.
FO2 - With Arm: this option will trigger AUX 1 (output time based on feature 2-08) any time
the CM2500 is locked/armed the first time (I.e., if you send a second lock/arm command it will
not trigger again)
FO3 - With Disarm: this option will trigger AUX 1 (output time based on feature 2-08) any
time the CM2500 is unlocked/disarmed. Note: the system must be in the armed state when
disarming to trigger AUX 1. (I.e., if the vehicle is already in the unlocked/ disarmed state and
you send a second unlock/disarm command it will not trigger the output)
FO4 - Ignition off: this option will trigger AUX 1 (output time based on feature 2-08/AU1
setting) any time the Ignition is removed or shut down.
2-11 Aux 2 Output Control: This feature allows the user to configure the method of which Auxiliary 2
can be activated.
FO1 - Remote: (default) This option allows AUX 2 (output time based on feature 2-09) to be
triggered by any 4 button Firstech remote or drone.
FO2 - With Arm: this option will trigger AUX 2 (output time based on feature 2-09) any time
the CM2500 is locked/armed the first time (I.e., if you send a second lock/arm command it will
not trigger again)
FO3 - With Disarm: this option will trigger AUX 2 (output time based on feature 2-09) any
time the CM2500 is unlocked/disarmed. Note: the system must be in the armed state when
disarming to trigger AUX 1. (I.e., if the vehicle is already in the unlocked/ disarmed state and
you send a second unlock/disarm command it will not trigger the output)
FO4 - Panic: this option will trigger AUX 2 (output time based on feature 2-09/AU2 setting)
any time the panic feature is activated by the user
2-12 Shock Sensor port (red 4 PIN port): This feature will determine the impact sensor port INPUT
function, using PIN 2 (zone 1) and PIN 4 (zone 2)
FO1 – FT SHOCK II: This option will allow the CM2500 to support the new FT SHOCK II
which is comprised of the standard analog 21 stage impact sensor combined with a digital tilt
sensor. The FT SHOCK II impact sensitivity will be adjusted using the dial on the front of it, the
dial can be set from OFF to 1-10, with 1 being the LEAST sensitive and 10 being MAXIMUM
sensitivity. The digital tilt will be fixed at 2.5 degrees to trigger.
To Next Page
Loading...