Firstech CM6200

To Next Page

To Previous Page

STEP 4: Once you get two parking light flashes, you are ready to test your DAS.

Testing The DAS Sensor

STEP 1: Turn the ignition off and Arm/Lock the system.

STEP 2: Wait 30 seconds then test the impact sensitivity.

Secure Valet Switch

The optional Secure Valet Switch prevents the alarm from being put into valet mode through cycling the

ignition on/off five times. The Secure Valet Switch is more secure than traditional toggle / valet switches

because it requires a two digit code. To program this feature you must perform the following procedures:

STEP 1: Turn on Option 3-10-III.

STEP 2: Turn ignition key to the “on” position.

STEP 3: Hold down the valet switch for 1.5 seconds. The LED on the valet switch will begin to flash rapidly with

successful completion of this step.

STEP 4: Enter the first digit of the desired two-digit pass code by depressing the switch the number of times that

coordinates with the desired first number. For example, to enter 3, depress the switch 3 times, then wait.

STEP 5: The LED will confirm the first number by flashing BLUE slowly. Once the LED begins to flash rapidly, enter

your second number by repeating step 4.

STEP 6: Turn the ignition off - the Secure Valet Switch is now programmed. Follow steps 3 – 5 to enter your Secure

Valet code.

**The first two digits of the RPS unlock/disarm pass code will be the default pass code for the Secure Valet

(you do not need to program them independently).

Thermister (Temperature Sensor)

Every 2 Way LCD Firstech RF kit includes an optional thermister, which must be plugged into the 2 pin

port of the control module for use. This plug is blue on the CM6200. The use of the thermister allows the

2 Way remote to display the vehicle’s interior temperature on the remote LCD (liquid crystal display) as

well as permitting the vehicle to start with timed Hot or Cold starting; see options 2-05, 2-07 and 2-08.

IMPORTANT: Plug is a blue 2 pin connectors on the CM6 series but thermisters with white plugs will work.

CM6200 Install Guide

Starter System

www.firstechonline.com | www.compustar.com

Page 8

Firstech CM6200 - Page 8