Fischer Panda 8000 - Replacing the Flame Glow Plug

Maintenance Instructions
Seite/Page 172 - Kaptitel/Chapter 7: Maintenance Instructions 18.12.15
7.21.1 Replacing the Flame Glow Plug
NOTE:Representative procedureThe described procedure is representative for Fischer Panda
generators. The original location of the item must be taken
from the generator description of this manual. All
replacements and repairs can be done by the user.
Fig. 7.21.1-1: Flame glow plug1. Pull connector off the flame glow plug.
Fig. 7.21.1-2: Flame glow plug2. A large piece of cloth or absorbent tissue must be placed
under the connection to prevent escaping fuel from
running into the capsule.
3. Loosen the screw on the flame glow plug using a wrench
with a W.A.F of 12 mm (01).
Use a wrench with a W.A.F of 13 mm (02) for the counter
nut.
4. Remove the fuel hose.
Fig. 7.21.1-3: Flame glow plug5. Loosen flame glow plug with a wrench with W.A.F. of
13 mm (01) and remove flame glow plug.
Use a wrench with a W.A.F of 24 mm (02) for the counter
nut.
6. To reinstall, reverse the order of steps.
01
02
12
13
01
02
13
24