Maintenance Instructions
Seite/Page 114 - Kaptitel/Chapter 7: Maintenance Instructions 9.2.16
7.18 Replacing the fuses
NOTE:Representative procedureThe described procedure is representative for Fischer Panda
generators. The original location of the item must be taken
from the generator description of this manual. This
replacement can be done by the user.
The fuses should be replaced every 2000 operating hours.
Fig. 7.18-1: FuseFigures similar!
1. Remove the two fixing screws of the plastic cover using a
size 0 or 1 phillips screwdriver.
Reprasentative picture
Fig. 7.18-2: Fuse2. Remove the plastic cover.
Reprasentative picture
Fig. 7.18-3: Fuse3. Using the fuse extraction tool, remove the fuse and
replace it with a new one.
4. To reinstall, reverse the order of steps.
Reprasentative picture
To Next Page