321144
34
4.21 Interior Light
The interior light of this cabinet uses a LED mounted on a small PCB board located in the roof of the PC
(and FC in some models). The light fittings can be rectangle or oval.
On opening the door, the light has a soft start feature, increasing in brightness to a preset level. To prevent
overheating of the lens cover, the lamp is turned off after 5 minutes if the door is left open, and the module
will beep continuously indicating that the door has been left open.
“T” models have one LED on the PC board; “B” models have either two or three LEDs on the PC board.
The power/control module controls the light.
“T” Model PCB Board Board in Housing
“B” Model Board, Housing & Cover
Diagram
0
NOTE: It is important that the polarity to the LED lamp is correct, as it will not operate if transposed.
To Next Page
Loading...
