Fisher & Paykel 635 Active Smart - Changing the Water Filter; To Reset the Filter Icon; To Disable the Filter Alarm

321144
56
9.5 Changing The Water Filter
• Turn water off. It is also recommended that the pressure is released by dispensing water with the
tap off.
• Grasp and firmly twist the cartridge in an anticlockwise direction (to the left when installed in the
recommended orientation).
• Pull the cartridge away from the filter head (down when installed in the recommended orientation).
• Discard the old filter.
• Remove the protective cap on the spigot on the head of the new cartridge.
• Push the cartridge upwards towards the head while rotating it in a clockwise direction (to the right
when installed in the recommended orientation).
• Reset the filter icon on the display (this will be set to remind the customer the filter is due to be
replaced).
Diagram
9.5
9.6 To Reset The Filter Icon
• Press the UP and LOCK buttons for 4 seconds to reset the filter monitor.
Note: Do not reset the monitor before the filter is changed, or monitoring will be inaccurate.
9.7 To Disable The Filter Alarm
Disable the alarm if no filter is to be fitted.
• Press and hold the MENU, UP and LOCK buttons for 4 seconds to turn this feature on/off.