321144
99
12.24 Fan Cover Removal Tool (T Models Only)
The following illustration shows a tool that can be made in your workshop. This tool can be used to release
and remove the freezer compartment fan cover in the Active Smart
®
“T” model refrigerators. If preferable,
the tool can be made from a screwdriver with a shaft length of approximately 200mm (8 inches) long and 4.5
mm (
3
/
16
inch) diameter.
B models are removed by grasping the bottom of the evaporator cover and pulling up and forward.
Diagram
12.24
12.25 Active Smart
®
PC/FC Fan Motor Tester
Testing a PC or FC fan motor with a multi meter is not possible, due to the electronics contained within the
motor. The simple way to test a fan motor is to apply a DC voltage with a 9-volt battery.
Parts required are:
Component
Qty Part Number
JST Plug 2 Pin 1 819611
JST Pin Terminal 2 819610
A 9-volt battery terminal connector obtainable from any electronic goods supply store.
A 9-volt battery
NOTE: When wiring the plugs, ensure that the polarity is correct, as the motors will not run if the polarity is
reversed.
To Next Page
Loading...
