7
PRIOR TO INSTALLATION
Fisher & Paykel is not liable for any damage caused by not following these instructions.
z
Please read the instructions carefully.
z
Unpack the rangehood.
z
Ensure the voltage (V) and the frequency (Hz) indicated on the rating plate match
thevoltage and frequency of the installation site.
z
Check all functions are working.
z
Check that the area behind the installation surface to be drilled is clear of any electrical
cables or pipes etc.
z
The rangehood surfaces can be damaged during installation if grazed or knocked
bytools. Please take care to protect the surfaces during installation.
z
Protect the cooktop surface with cardboard, or the like, to prevent damage
occurringwhilst the rangehood is being installed above.
z
Temporarily mark the height of the bottom of the rangehood and the centre of the
cooktop on the wall according to the information given in the ‘Installation Height’ section.
z
The wall used for mounting the rangehood should have sufficient strength and a
flatsurface.
z
A power outlet should be within 750mm of the rangehood and can either be on the wall,
behind the chimney or in the ceiling.
To Next Page
Loading...
Need help?
General
