Fisher & Paykel ACTIVESMART RS36A80 - Water and Power Supply Connection

18
Connect to water
(for Ice and Water models only)
1
Move the appliance in front of the
cabinetry close enough toallow access
behind for power and water connections.
2
At the front of the appliance, insert the
adaptor of the braided water line hose
(A) into the PRV.
Note: If using a 1/4PEX plastic tubing,
you need to use awater fittings kit (not
supplied and must purchase separately).
D
C
B
Water fittings kit
(Ice and Water
modelsonly)
Collet locking clip
(1)
1/4” (6mm) Stainless
steel braided hose with
adaptor (1)
6
At the back of the appliance, connect the freeend
of the braided hose to the water supply (E), and
then loosely coil the water line hose (~2 – 3 times).
– Do not over-tighten the connection.
– Turn ON the water supply and check that all
connections are dry and free of drips.
Connect to power supply
7
Locate the power cord and connect the fitted
plug to the electrical supply (115VAC, 60Hz)(F).
Turn ON the appliance to test if working.
– If using an isolating switch, turn OFF the
appliance before continuing theinstallation.
IMPORTANT!
●
Ensure that the water connection is performed by a professional installer.
●
The standard appliance includes a braided water line hose compatible
withabrass adaptor.
●
Ensure there is enough tubing for the water connection and to pull
theappliance out for service, if required.
●
Flush water through the hose prior to connection to the appliance
toremoveany debris in the hose.
●
We recommend to use an isolating switch that can be accessed
easilyafterthe appliance is installed.
WATER AND POWER SUPPLY CONNECTION
3
Insert the tube end of the adaptor fully
into thePRV. Once inserted, pull gently
on the tubing to ensure it is locked in (B).
Note: Dislodge the PRV from the clips,
ifrequired.
4
Secure the connection by inserting a
lockingkey between the PRV and tube
endoftheadaptor (C).
– If the PRV is dislodged during
installation, mount the PRV back
intothe clip.
5
Thread the free end of the water line hose
intothe hole located at the base and
throughthe back of the appliance (D).
E
F
PRV
braided
hose with
adaptor
A