!3 REMOVING HINGE END CAPS
!4 LEVELLING YOUR APPLIANCE
It is important that all four corners of the product is supported firmly
onto the floor to eliminate any movement.
Installing the appliance on a soft or uneven/unlevelled floor may result
in twisting of the product and poor door sealing.
Raise the product using an 11 mm hex socket or 4 mm hex Allen key.
One turn of height adjusting nuts is equivalent to 1 mm height travel.
Note: maximum torque travel 20mm.
1 Carefully open the French doors and remove hinge end caps.
2 Left hinge end cap
Hold onto the corner of the end cap,
firmly push to the right to disengage
securing hook and pull down.
3 Pull cap gently towards the left hinge
to remove.
4 Right hinge end cap
Press on the centre of the end cap
and push towards the right hinge
to remove.
1 Raise the front of the product until the
fixing brackets contact the ceiling of
the enclosure (refer to B).
Turn clockwise to raise roller or
counter-clockwise to lower roller.
Repeat on opposite side.
2 Raise the rear of the product until
the refrigerator doors are flush with
the front face of adjacent walls.
Turn clockwise to raise roller or
counter-clockwise to lower roller.
Repeat on the opposite side.
Gently push the front of the product
to check the stability and to ensure
side gaps are even with enclosure.
B
Reserve end hinge cap
for later installation
Reserve end hinge cap
for later installation.
14
To Next Page
Loading...
