19
@0 FRONT FEET, FITTING KICKSTRIPS AND COVERS
2 Kickstrip filter
Remove filter from inside the product.
Fit the filter onto the rails and push to
the rear until it clips securely.
3 Kickstrip grille
Align grille onto securing hooks. Push grille
firmly onto product until it clips securely.
1 To stabilise the product, lower the front
feet. Turn clockwise to lower feet.
Repeat on the opposite side.
5 Conceal the outer top studs using top
covers. Firmly push top cover over top
door studs.
Repeat x1 each French door and
x2 Drawer
4 Remove any remaining
protective film on all door panels.
6 Conceal the side studs using side covers.
Firmly push side cover over side studs.
Repeat x4 each French door and
x2 Drawer
To Next Page
Loading...
