18
!8 FIXING BRACKETS AND REPLACING END HINGE CAPS
!9 INSTALLING WATER FILTER CARTRIDGE (ICE & WATER MODELS ONLY)
ImpORTANT!
The water filter head must be firmly pushed
into the product and secured, incorrect
installation can lead to water leaks.
3 Turn 90° clockwise to tighten. Remove filter
cartridge tool and close freezer drawer.
1 Secure fixing bracket hole to
the ceiling of the enclosure
with wood screw x1.
Repeat on the opposite side.
3 Hold onto the corner
of the end cap, firmly
push up and to the left
to engage securing
hook. Ensure cap is
flush with the product.
4 Right hinge end cap
Align hinge cap to
product. Press and firmly
slide the cap to the left.
Ensure cap is flush with
the product
2 Pull freezer drawer slightly open to fit
filter cartridge tool.
Align the filter cartridge tool over the
filter. Insert the filter cartridge and tool
into the bottom left of the product, firmly
push the cartridge in until the filter head
cannot be pushed any further.
1 Remove the red protective cap on the
spigot head.
2 Left hinge end cap
Align hinge cap to the
product. Press and
firmly slide the cap to
the right.
4 Filter cartridge shown in the locked
position.
To Next Page
Loading...
