Fisher & Paykel DE09 - Drum Rear Sleeve and Shaft Replacement; Drum Baffle Replacement; Front Bearing Assembly and Front Panel Component Replacement

479536
23
4.2.1 Drum Rear Sleeve And Shaft Replacement
• Remove the drum.
• Remove the o-ring from bearing shaft.
• Remove the sleeve.
• Remove the three securing screws from
inside the drum to remove the shaft and
deflector.
Reassembly is the reverse procedure.
O-ring
Sleeve
Deflector
4.2.2 Drum Baffle Replacement
• Remove the drum.
• Remove the screws for the baffle and remove the baffle.
Reassembly is the reverse procedure
4.2.3 Front Bearing Assembly and Front Panel Component
Replacement
• Remove the front panel from the cabinet.
• Remove the light globe.
• Unclip the top of the bearing holder from the top of the front panel.
• Pull the holder away from the panel and pull upward to remove the holder.
• To remove the slides, pull out the unclipped side and then unclip the other side.
• To remove the drum felt, unhook the right side and pull out. The new felt is just pushed into
place and hooked to the right.
• To remove the light socket, disconnect the terminals off the light switch and sensor plug, and
then unscrew the socket.
• To remove the light switch, disconnect the terminals, keeping note of the positions, and unclip
the switch.
Reassembly is the reverse procedure.