427939
15
6.16 Timer Removal DE40F56A & DE50F56A
1. Remove the timer knob refer to sec 6.1
2. Remove the top panel refer to sec 6.3.
3.
Remove the 2 small screws adjacent to the timer shaft on the outside front of the cabinet.
4. Remove all the screws holding the door hinge assembly such that the wiring shield is free.
5. Move the timer away from the cabinet
6. Disassemble timer cover from the wiring shield
7. Remove the wires from the timer.
Reassemble in the reverse order. Do not use longer screws into the timer other than those
provided or the timer will be damaged.
6.17 Electronic Controller Removal DE50F56EW
Use wrist strap and take standard ESD precautions.
1. Remove the front panel refer to sec 6.2
2.
Disconnect sensor and door switch connector.
3. Disconnect the remaining wiring harness.
4. Release the lower retaining clips holding module to control panel.
5. Module can now be removed from the front panel.
Reassemble in reverse order.
6.18 Door Assembly removal
1. Open door fully.
2. Remove the 2 screws that retain the door hinge cover and remove the cover.
3. Support the door with one hand, then remove the screw retaining lower hinge.
4. The door assembly can now be lifted off the top hinge. Note the location of spacer washers.
Reassemble in reverse order.
6.19 Door Switch removal DE40F56
1. Remove the drum assembly refer to 6.5
2. Open the door fully and remove the 2 screws holding the door switch housing.
3. Move the housing away from the cabinet.
4. Remove the wires from the switch.
5. Remove the switch from the housing.
Reassemble in the reverse order. Do not use longer screws into the door switch housing other
than those provided or the housing will be damaged.
6.20 Door Switch removal DE50F56
1. Remove the top panel assembly refer to 6.3
2. Remove the control module housing for the DE50F56EW refer to sec 6.17.
3.
Unclip the switch from the duct assembly.
4. Remove the harness wires from the switch.
Reassemble in the reverse order.
To Next Page
Loading...
