Fisher & Paykel DE40F56A2 - Exhaust Sensor & Door Switch Test

427939
18
7.3 Exhaust Sensor & Door Switch Test
1. Start the dryer running in Low or Regular Temperature mode; then press and hold the LOCK
button, and then press the START/PAUSE button.
Note: This advances the drying cycle so that a shorted temperature sensor can be detected.
(Refer to Faulty Exhaust Sensor section).
2.
Press and hold the LOCK
button; then press the DRYNESS button. Release these
buttons and press the START/PAUSE
button.
 If there is a fault with the exhaust sensor, the fault code will be immediately displayed, with
the beeper sounding (Refer to FAULT CODES section).
3.
Open the door and the machine should pause. The three delay LEDs will turn on with the
door opened.