599735A
12
Component Specifications Comments
Heater Plate 230V
Water Heater Track
Power Supply
Resistor
230V AC
50 Ohms +/- 4 Ohms
98 Ohms +/- 7 Ohms
NZ, AU, GB, EU, DK
Heater Plate 110V
Water Heater Track
Power Supply
Resistor
120V AC
24 Ohms +/- 3 Ohms
24 Ohms +/- 3 Ohms
US, TW 110V NZ/AU
Temperature Sensor 12000 Ohms @ 20
O
C (68
O
F)
8300 Ohms @ 30
O
C (86
O
F)
3000 Ohms @ 60
O
C (140
O
F)
Located on the heater Plate
Fusible Link 268 – 302
O
C (514 – 576
O
F) Located on the heater plate
Water Inlet Hose 1000Kpa / 145 P.S.I.
1561 mm from LHS
1344 mm from RHS
Pressure rating
Length from chassis edge
(viewed from the front)
Water pressure 1 MPa (145 psi) max, 0.1 MPa (14.5
psi) min
1 MPa (145 psi) max, 0.03 MPa (4.3
psi) min
Water softener models
Non water softener models
Drain Hose
2011mm from LHS (79 inches)
1794 mm from RHS (71 inches)
Length from chassis edge
(viewed from the front)
Power Cord 1776 mm from LHS (69 Inches)
1559 mm from RHS (61 Inches)
Length from chassis exit
(viewed from the front)
Drying Fan 24V brushless DC motor 0.27A
Approximately 2 to 3 Meg Ohms
Polarity sensitive
Meter +ve to red wire, -ve to
black wire
Diverter Valve
Softener Assy
24V DC Coil
65 +/- 10 Ohms Coil
Brine Pump Assy 24V DC Coil
65 +/- 10 Ohms Coil
Water Softener 500 grams Salt Capacity
Approximately 14 regenerations
290+/- 10ml Resin
Lid Actuator
24 V DC
Approximately 30 Ohms
Hall Sensor 4.13, and 3.43 mOhms
measured +ve in centre, -ve to outside
LCD LCD has back light 5 volt rail between pins 2 & 5