599735A
49
8.8 Drying Fan and Flap Valve
1. Remove the drawer front (refer to Section
8.2).
2. With a small bladed screwdriver, carefully release the small
plastic clips holding the rinse aid indication LED in place in
the dispenser and remove the LED.
3. Release the rubber tabs securing the fan.
4. Disconnect the wire harness from the electronic controller.
5. The drying fan will now come free.
Refit in reverse manner.
Note: The fan housing flapper can be replaced by removing the
cover and lifting the flapper out of the housing.
To remove the cover, use a small screwdriver to depress the 2
clips at the rear, and slide it forward.
8.9 Water Softener (Where Fitted)
1. Remove the drawer front (refer to Section
8.2).
2. Disconnect the wiring loom connections to the water
softener diverter valve, brine pump and salt level
detector, and remove the dispenser wiring loom
connection to the electronic controller.
3. Use a flat blade screwdriver to open the salt level
indicator LED cover, and remove the LED from the water
softener.
4. Unclip the fill hose to strainer and remove the dispenser
hose from the water softener.
5. Remove the four T10 torx drive screws securing the
water softener to the tub.
6. The water softener can now be removed from the
product.
To refit:
1. Place the overflow ‘O’ ring on the water softener and
lubricate the tub overflow with a water-soluble lubricant
e.g. Glycerol or similar.
2. Place the salt tank ‘O’ ring in the tub. Lubricate the salt
tank flange on the water softener. Pass the dispenser
wiring loom through the water softener and plug it into
the electronic controller.
3. Place the water softener in the tub and apply enough
pressure to seat the ‘O’ rings.
4. The overflow should sit almost flush with the inside of the
tub. The salt tank should be recessed by approx 1mm
(1/32 inch) from the inside of the tub.
5. Refit the screws, strainer, hoses, harness connectors
and LED.
To Next Page
Loading...
