599735A
50
8.10 Strainer (Where Fitted)
1. Remove the drawer front (refer to Section
8.2).
2. Remove the water softener hose from detergent
dispenser spigot.
3. Place screwdriver under clip and use leaver action to
disengage the clip.
4. When clip is disengaged, the strainer can be pushed
down off the water softener spigot.
5. After removing the hose clamp, the strainer can now be
removed from the DishDrawer.
Refitting:
Fit new strainer & position hose clamp.
1. Manoeuvre strainer into place.
2. Slide into spigot using a force applied in direction 1.
Lock into place, and ensure correct fitting by pushing in
direction 2.
3. Fit dispenser hose to detergent dispenser spigot.
8.11 Detergent Dispenser
1. Remove the drawer front (refer to Section
8.2).
2. Disconnect the two wiring loom connections from the
dispenser coils. Note: Push back the locking tabs to allow the
connectors to release.
3. With a small bladed screwdriver, carefully release the small
plastic clips holding the rinse aid indication LED in place and
remove the LED.
4. Use pliers to release the clamp and remove the fill hose from
the dispenser.
5. While holding the dispenser, unscrew the six T10 Torx drive
screws securing the two brackets to the dispenser.
6. The dispenser can now be removed from inside the tub.
7. To open up the dispenser door fully, first open the door using
the release catch, then squeeze the top sides of the door
together. This will release the door to the fully open position.
This can be done with the dispenser in place.
Refit in reverse manner ensuring the dispenser gasket is located
correctly.
To Next Page
Loading...
