599735A
46
Connector Location
Connector Harness
P101 Power
P205 Chassis
P201 Motor
P303 LCD/Badge
P302 Comms
P202 Water Softener
P203 Fan
P204 Dispenser
8.2 Drawer Front
1. Open the drawer.
2. Locate the drawer pins on either side of the tub.
If the pins cannot be accessed, remove the tub from the
slide first (refer to Section
8.6).
3. Use pliers to pull on the pin and remove it. Support the
drawer front with your hand while doing this to prevent it
dropping onto the floor.
4. With both pins removed, the bottom of the drawer front can
now be eased downward slightly.
5. Pull the drawer front down to free it from the handle and
the top locating slots in the tub.
6. Remove the earth wire from the tab on the drawer front. (If
it is an integrated model, it will be necessary to unplug the
integrated badge from the badge isolator.)
Refit in reverse manner, ensuring the earth wire is
reconnected, drawer slides are fully forward and the pins
secure through the hooks on the front end of the slides.
Note: When reinserting the pins, ensure that the dividing web
is vertical as shown.
P303 P201 P205 P101 P302
Controller
(Front View)
To Next Page
Loading...
