599735A
30
5.2 Diagnostics Quick Reference Charts
5.2.1 Fault Display/Download Mode
Press and hold KEYLOCK, then press START/PAUSE for 5 seconds.
All LEDs & LCD segments except Keylock are illuminated.
Press START / PAUSE.
This initiates a pen data download via the lower tub-home light pipe. At the same time, the
current and then the previous fault code will be displayed in the LCD screen and on the
secondary control panel LEDs. To read the fault code on the secondary display, refer to
Section 6.1 on fault codes.
Press KEYLOCK.
This will clear the current fault code. Note: If Keylock is pressed again, the previous fault
code will be removed. Pressing Keylock also toggles the wash icons on the LCD on and off.
Press POWER to exit.
5.2.2 Hardware Output Test Mode
Press and hold KEYLOCK, then press START/PAUSE for 5 seconds.
All LEDs & LCD segments except Keylock are illuminated.
Press POWER once.
HO will show in the display (integrated: Heavy, Normal, Fast, Delicate, Rinse LEDs showing).
Press START/PAUSE.
Scroll through the following outputs using Start/Pause. Turn the outputs on and off using the
KEYLOCK button.
Press POWER to exit.
Note: Scrubbing brush symbol = output on. No scrubbing brush symbol = output off (on
integrated models a green LED above the start/pause button is used in place of the scrubbing
brush).
LCD Norm Fast Deli Rinse Hardware Output
Display LED LED LED LED
-------------------------------------------------------------------------------------------
bL Off Off Off On Backlight
Er Off Off On Off Element Relay on for only 5 seconds
Ld Off Off On On Lid Motors (will run for 10 seconds)
dd Off On Off Off Detergent Diverter Valve
FU Off On Off On Fill Water Valve
P1 Off On On Off Motor Wash direction (2300-2850 rpm) only if
tub closed
P2 Off On On On Motor Drain direction (5000 rpm) only for 255
seconds
rd On Off Off Off Rinse Aid Dispenser (dispenses current setting)
dF On Off Off On Drying fan
LE On Off On Off Rinse Aid and Water Softener LEDs
C1 On Off On On Water Softener Diverter Valve
C2 On On Off Off Water Softener Brine Pump
C3 On On Off On Water Softener Brine Valve
O
C On On On Off Displays current water temperature.
O
E On On On On Displays controller rail voltage
Tub Home Sensor test: - keylock symbol on = tub closed, off = tub open
To Next Page
Loading...
