To Next PageTo Next Page
Need help?Do you have a question about the Fisher STEEL-CASTER and is the answer not in the manual?
General| Material | Steel |
|---|---|
| Drive System | Hydraulic |
| Plow Compatibility | Yes |
| Hopper Material | Steel |
| Model | STEEL-CASTER |
| Category | Spreader |
| Mounting | Truck |
| Spreading Width | Up to 40 feet |
| Use | Salt and sand spreading |
| Capacity | 0.35, 1.0, 2.5 cu yd |
Lists crucial safety rules to prevent injury and damage during operation.
Procedures for securing the hopper unit into a truck bed.
Guides for attaching and adjusting the material chute for gas models.
Detailed steps to attach the chute to the spreader for gas units.
Guides for attaching and adjusting the material chute for hydraulic models.
Detailed steps to attach the chute to the spreader for hydraulic units.
Steps for wiring the spreader harness for gas engine models.
Guide for installing the vehicle control harness into the cab.
Detailed steps for adjusting the choke on Honda engines.
Overview of the recommended sequence for hydraulic unit setup.
A comprehensive checklist for verifying all installation and adjustment steps.
