FLAMMA FX200 - Looper Mode and Data Management

In the REC or DUB mode, press in to start PLAY. The footswitch LED indicator will turn BLUE. PLAY
will be highlighted on the screen and the progress bar will be shown in BLUE. Press to STOP playing,
the footswitch LED indicator will blink in YELLOW, and STOP will be highlighted on the screen. The
progress bar and timer will be cleared.
PressFootswitchAtoturnontheONESHOTfunction,thefootswitchLEDindicatorwillturnYELLOW.
IfyoustarttoPLAY,therecordedtrackwillbeplayedonlyonceandthenstop.TheONESHOTwill
beoffafterplayingisfinished.YoucanpressFootswitchAduringthefirstplaybacktocancelONE
SHOT,andtherecordedtrackwillbeginlooping.
PressandholdFootswitchAfor2secondstoclearalloftherecordedtrack.Afteritiscleared,
thefootswitchLEDindicatorwillturnWHITEandCLEARwillbehighlightedonthescreen.
www.flammainnovation.comShenzhenFlammaInnovationCo.,Ltd
21
Looper
Notes:
1.Whentherecordingcapacityisfull(52seconds),thelooperwillstoprecordingand
switchtoPLAYautomatically.
2.LooperdatawillbeclearedaftertheFX200ispoweredoff.
3.YoucansetuptheloopermodeintheMENU-SYSTEM-LOOPER.PREmodeforputtingthe
looperatthefirstpositionoftheeffectschain,whichallowsyoutorecordthedryguitar
signalforparameteradjustment;orPOSTmodeforputtingthelooperattheendofthe
effectschain,whereadjustingeffectswillnotaffecttherecordedsignalplayback.