Open the box, take out the user manual and the USB flash disk.
Remove the foam.
Lift the printer and put it on the desk, then take Artemis out of the plastic bag.
Remove the top foam, there should be a power cable included.
Take out the foam under nozzle.
Hold the platform and lift it carefully to remove the foam below it.
Discard the protective tapes all around.
Cut the cable ties which for fixing X-axis and Y-axis synchronous belt.
Cut the cable ties that used to hold the rods in place.
Cut the cable ties that used to hold the platform. Discard the protective tape around
it.
You’ve unpacked your printer. Please keep the kit and packing for future use.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Unpacking
04
To Next Page
Loading...
