1. Tap [Filament], tap [Change], extruder starts
pr
eheating.
2. Open the filament cover.
3
. Pull out the filament as the picture
showed
above.
5
. Tap [ok] after plugging in new filament, loading
starts. When new filament come out of extruder
steadil
y, replace is completed, tap [OK].
4
. Insert new filament into the filament
intak
e and push the filament into the
f
eeding wheel until resistance is sensed.
Change Filament
6. Put the spool of filament
on
the spool holder, close
the
filament cover.
235
/235℃
OK
235
/235℃
OK
Pull out filament,
feed new filament, press [OK]
Press ok when new color appears
10
To Next Page
Loading...
