This guide is only applicable to FLASHFORGE Foto 13.3 3D printer
Foto 13.3
EN/CN-A02
1. When the glass over the LCD screen cracks, stop printing immediately, otherwise
the crack will expand and cause more serious damage.
2. The maximum tank volume is 3 liters. Note that moderate resin must be added
so its level will be between the upper and lower marker lines in the tank.
3. The correct way to cut off power supply is to turn off the power switch of the
printer.
4. Do not cut off the power abruptly during printing to avoid mechanical damage.
WARNING
To Next Page
Need help?
General
