06
2. Tap [Filament]--Tap [Load]--After Load completed--Tap [OK]
3. Load completed when you see filament come out of extruder, Tap [OK].
Put the spool of filament on the spool holder, close the filament cover.
Build
Tools
Filament
Load
Change
200
/235℃
Heating extruder...
Cancel
235
/235℃
Preheat completed,
Begin loading...
ok
235
/235℃
Press ok when new color appears
Mind the loading direction of filament, make sure
to be clockwise as the picture showed.
ok
To Next Page
Loading...
