Flashforge Adventurer3 - Model Print; Selecting and Starting a Print Job; Print Completion Notification

07
1. Tap [Build], choose the file path: Print from local memory card.
2. Locate the model file in the model list, Tap
on its right to start printing;
or tap model file picture or file name to enter model details page, tap to start printing.
3. Extruder will heat up and printer will start printing after heating completed. After model
printing finished, printer will sound a beep and pop out notice on touch screen.
Model Print
Build
Tools
Filament
6.67GB
No job
Not Available
1/3
< <
...
0
h
10
min
Time Remaining
m
7.49
20mm_Box-
PLA.gx
20mm_Box-PLA.gx
20mm_Box-P...
0 h 10 min
0.70M
Build completed!
ok