Flashforge Creator 3 - Page 5

03
11. Plug power cable into the input on the back and turn on the power switch. Tap[Tools], [Manual].
ToolsPreheatBuild
Setting Status About
Filament Level Home Manual
HOME
<
14. Now you’ve unpacked your Creator 3.
12. Tap [Z-] to partially elevate the build plate. 13. Remove bottom foam pieces.
<
X
X
Y
Z
0.00
0.00
0.00
0.00
Y +
X -
X -
X +
X +
Z -
Z +
Y -