Flashforge Inventor 2 - Unloading Filament; Prepare for Filament Removal; Execute Filament Unloading

14
Extruder
Unload started, press down on the
spring lever and withdraw filament
2. Tap [Tools].1. Pull filament guide tube out of filament intake,
leave filament 10cm to pull filament easily.
Please follow steps below if you need to unload filament in
daily use.
3. Tap [Filament]. 4. Tap [Unload].
Unloading Filament
Press here
Push filament down
through for
3 seconds
Withdraw
filament
Press here
Done
5. When heating to target temparture, press
spring presser and push filament down through
for 3 seconds, until you see steady filament
coming out from nozzle.
6. Then pull out vertically quickly and release
spring presser. Tap [Finish], go back. Tap return
arrow to go back to home screen.